Genie Z-34 - Manual (Page 22)

Operator's Manual Fourth Edition • Third Printing
20 Z-34/22 IC Part No. 1000048
Test Limited Drive Speed
37 Press down the foot switch.
38 Raise the primary boom 1 foot / 30 cm.
39 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not exceed
1 foot / 30 cm per second.
40 Lower the boom to the stowed position.
41 Raise the secondary boom 1 foot / 30 cm.
42 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the secondary boom raised should not
exceed 1 foot / 30 cm per second.
43 Lower the boom to the stowed position.
44 Extend the primary boom 1 foot / 30 cm.
45 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 1 foot / 30 cm per second.
If the drive speed with the primary boom raised or
extended or the secondary boom raised exceeds
1 foot / 30 cm per second, immediately tag and
remove the machine from service.
Test Auxiliary Controls
46 Shut off the engine.
47 Pull out the red Emergency Stop button to the
on position.
48 Press down the foot switch.
49 Simultaneously hold the auxiliary power switch
on and activate each function control handle or
toggle switch.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate. Drive function should not operate with
auxiliary power.
Test the Lift/Drive Select Function
(if equipped)
50 Press down the foot switch.
51 Move the drive control handle off center and
activate a boom function toggle switch.
Result: No boom functions should operate. The
machine will move in the direction indicated on
the control panel.
FUNCTION TESTS