GE PCVH480EK - Manual (Page 30)

INSTALL BRACKET TO WASHER
A. Remove washer top cap screw from the rear
left. Align left bracket holes with top cap screw
hole on rear left of the unit and replace screw.
NOTE: Leave screws loose so dryer hole
alignment will be easier.
B. Drive next screw through the bracket into
the rear of the washer.
C. Repeat the above steps with the right side.
3
INSTALL DRYER AND BRACKET
ON DRYER
A. Lift the dryer on top of the washer. Protect the
washer control panel with cardboard or other
protection. Be sure to lift the dryer high enough
to clear the washer control panel.
WARNING –
Potential
Personal Injury. More than two people are
recommended to lift the dryer into position
because of its weight and size. Failure to do
so could result in personal injury or death.
B. Align the holes in the bracket with the holes
in the back of the dryer. Using a Phillips
screwdriver, attach the 2 #8 x 1/2
″ tapping
screws.
C. Tighten the dryer bracket screws; then tighten
all stacking kit screws.
4
FINALIZE THE INSTALLATION
A. Refer to the washer Installation Instructions
to complete the washer installation.
B. Refer to the dryer Installation Instructions
to complete the dryer installation.
C. Carefully slide or walk the stacked washer and
dryer into place. Use felt pads or other sliding
device to assist moving and to protect flooring.
WARNING –
Potential Personal
Injury. Do not push on the dryer once installed
to top of the washer. Pushing on the dryer may
result in pinched fingers.
5
Place
hands
here
Place
hands
here
Installation Instructions
30
STACKING THE WASHER AND DRYER (if desired) (cont.)