GE GN75ENSRSA - Manual (Page 11)

Installation Instructions
11
CONNECTING THE WATER HEATER
TO THE GAS SUPPLY
2
Connect the gas supply to the system following
state and local plumbing codes. Use the supplied
ball valve at the inlet to the system. Make sure
the gas supply line to the water heater fits in the
diagram shown on page 7. This is essential if a pipe
cover accessory (model number AGTPCM) is to be
installed.
IMPORTANT: Use a pipe wrench to securely
hold on to the end of the water heater gas inlet
to prevent twisting the inlet.
IMPORTANT: Leave the gas valve off until
instructed to turn it on.
Gas Pressure
Test Port
Gas Shut-Off Valve
Gas Supply