Gateway E-2500D - Manual (Page 73)

68 www.gateway.com
Chapter 6: Troubleshooting
You see a “Not enough memory” error message
■ Close all programs, then restart your computer.
Modem (dial-up)
Your modem does not dial or does not connect
■ Make sure that the modem cable is plugged into the modem jack and not the
Ethernet network jack. See
“Back” on page 10 to make sure that the connections
have been made correctly.
■ Make sure that your computer is connected to the telephone line and the telephone
line has a dial tone.
■ Make sure that the modem cable is less than 6 feet (1.8 meters) long.
■ Remove any line splitters or surge protectors from your telephone line, then check
for a dial tone by plugging a working telephone into the telephone wall jack.
■ If you have additional telephone services such as call waiting, call messaging, or
voice mail, make sure that all messages are cleared and call waiting is disabled
before using the modem. Contact your telephone service to get the correct code
to temporarily disable the service. Also make sure that the modem dialing
properties are set correctly.
To check the dialing properties:
1
Click Start , then click Control Panel . The Control Panel window opens. If your
Control Panel is in Category View, click Printers and Other Hardware .
2
Click/Double-click the Phone and Modem Options icon, then click the Dialing Rules
tab.
3
Click the location from which you are dialing, then click Edit .
4
Make sure that all settings are correct.
Help and Support
For more information about troubleshooting memory errors, click
Start, then click Help and Support.
Type the keyword memory error in the Search box
, then click the arrow.
Help and Support
For more information about dialing properties, click Start, then click
Help and Support.
Type the keyword dialing in the Search box ,
then click the arrow.
8510807.book Page 68 Thursday, June 30, 2005 7:27 AM