GE ZVB30 - Manual (Page 9)

Before You Call For Service…
Save time
and money!
Review the
troubleshooting
tips on this
page first and
you may not
need to call
for service.
PROBLEM POSSIBLE CAUSE
FAN DOES • The vent is not fully extended. Press the raise/lower pad.
NOT WORK
• The blower control switch may be in the OFF position.
Slide it to the right.
VENT DOES • The vent is not plugged into an outlet. Plug the vent into a 120V
NOT WORK power outlet.
• The raise/lower pad did not engage the lift motor. Hold down the
pad for a couple of seconds to activate the motor.
• The circuit breaker may have tripped. Check the circuit breaker—
reset if necessary.
9
Care and Cleaning
Downdraft Vent System
Painted or
stainless steel
surfaces Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface,
use warm sudsy water or a stainless steel cleaner
or polish. Always wipe the surface in the direction
of the grain. Follow the cleaner instructions for
cleaning the stainless steel surface.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the location
of a dealer nearest you, please call our toll-free
number:
National Parts Center 800.626.2002 (U.S.)
888.261.3055 (Canada)
ge.com (U.S.)
www.GEAppliances.ca (Canada)
Grease filters
The efficiency of your downdraft depends on a
clean filter. Frequency of cleaning depends on the
type of cooking you do. Grease filters should be
cleaned at least once a month. Never operate the
downdraft without the filters in place.
To remove: Pull the filters out by grasping them
and pulling straight up.
To clean: Soak and then agitate in a hot detergent
solution. Light brushing may be used to remove
embedded soil. Rinse, shake and remove moisture
before replacing.
With careful handling, the filter will last for years.
If replacement becomes necessary, order the part
from your dealer.
Downdraft Vent System