GE ZV830 - Manual (Page 6)

6
The metal filter traps grease released by foods
from the cooktop. The filter also helps prevent
flames (from food, grease) from damaging the
inside of the hood.
For this reason, the filter must ALWAYS be in place
and the filter panel must ALWAYS be closed when
the hood is in use. The grease filter is dishwasher-
safe and should be cleaned every 6 months, or
as needed.
To remove:
1. Press up on the front two corners of the filter
cover panel to unlock. Lower the panel to access
the filter.
2. Press the filter latch in to release it. Pull the filter
down and out.
To replace:
1. Place the two tabs on the filter edge into the
lower locating slots in the left or right side of the
hood opening.
2. Push the filter up and snap it into place in
the hood.
3. Rotate the filter cover panel up into position and
press up on its front two corners to lock it into place.
To clean, swish the filter in hot soapy water and
rinse in clean water or wash it in the dishwasher.
Do not use abrasive cleansers.
NOTE: Some discoloration will occur in the
dishwasher.
Care and Cleaning
Chimney Hood
For your
safety Before servicing or cleaning the unit, switch power
off at the service panel and lock the service panel to
prevent power from being switched on accidentally.
If the service panel cannot be locked, fasten a tag or
prominent warning label to the panel.
Metal
grease
filter
Filter panel Grease will accumulate on the filter panel. The panel
is dishwasher-safe and should be cleaned every 6
months or as needed.
1. Press in to release and lower the filter cover panel.
2. Remove the hinge barrel nuts and screws on
both sides. Shift filter panel to the left and
remove.
3. Stand the filter cover panel in the dishwasher
with the drain holes facing the bottom.
NOTE: The filter must ALWAYS be in place and the
filter panel must ALWAYS be closed when the hood
is in use.
Press corners
to unlock
Filter latch
Barrel
nut (2)
Press corners
to unlock
Filter panel