GE JV694 - Manual (Page 5)

6. Open the filter panel.
Pull the visor slides out. Rotate the panel clips
and swing the panel open.
7. Install the mounting brackets.
Hold the left hand mounting bracket in place on
the side of the housing as shown.
Two (2) sets of screws are provided. Use the short
screws for flush bottom cabinets or long screws for
recessed bottom cabinets. Insert two (2) screws
through the housing and into the mounting bracket.
Do not tighten screws completely.
INSTALL THE HOOD
1. Mark and cut out the cabinet bottom.
Prepare the cabinet bottom as shown above. Be
sure to locate the cut-out and four holes from the
front of the cabinet to assure a flush mount.
2. Attach the damper/duct connector.
Use two (2) screws (provided) to attach the connector
to the housing. The damper flap should open in the
direction indicated by the arrow.
3. Remove the electrical knockout.
Choose either the top or side of the housing for the
electrical cable entrance. Remove the appropriate
knockout.
4. Set the housing into the opening.
Carefully lower the housing into the cabinet opening
with the slide control to the front.
5. Remove the access cover.
5
INSTALLATION INSTRUCTIONS
FRONT
OF HOOD
VISOR
SLIDES
PANEL
CLIP