Meridian America DSP33 - Manual (Page 41)

36
Troubleshooting
Green indicator on back panel not lit
Check the following:
❍ There is AC power connected to the socket on the back of the
DSP33.
❍ The power switch on the back panel of the DSP33 is turned
on.
If the DSP33 will still not illuminate, check any fuses in your
power supply and the fuse in the inlet of the DSP33. If these are
all intact, contact your dealer.
Remote not working
Check the following:
❍ The battery in the Meridian System Remote.
❍ See if the DSP33 has been set up as not controller in the
Meridian Configuration program; see Changing the setup
options, page 29. Note that this may be deliberate by your
dealer.
Unit goes silent when played hard
❍ DSP33 has a temperature sensing system on board, which
prevents overheating of the electronics. The sound will
continue when the speaker has cooled.
Drive units move when the speaker is
switched on or off
❍ This is normal as the speaker active electronics settle.
There is radio interference
The DSP33 is a digital audio and computing device which has
been designed to very high standards of electromagnetic
compatibility.
If this equipment does cause or suffer from interference to/from
radio or television reception then the following measures should
be tried:
❍ Reorient the receiving aerial (or antenna) or route the antenna
cable of the receiver as far as possible from the DSP33 and its
cabling.
Troubleshooting