Multiquip MQ Power Duelweld Welder/Ac Generator BLW-400SSW - Manual (Page 24)

PAGE 24 — BLW-400SSW- WELDER/AC GENERATOR — PARTS & OPERATION MANUAL — REV. #1 (06/15/01)
BLW-400SSW — OUTPUT TERMINAL OVERVIEW
Figure 8. Duplex Receptacle Detail
Figure 7. Output Terminal Panel
Figure 9. GFCI Test Button
120 Volt Receptacle
One GFCI Duplex Nema 5-20R (120V, 20 Amp) receptacle
is provided on the output terminal. This receptacle can be
used anytime the generator is in operation. The receptacle
is controlled by the circuit breaker located on the control
panel.
The reset button is for the GFCI when the circuit is tripped.
Pressing the "Test Button" (See Figure 9) in the center of
this receptacle will check the GFCI function. The receptacle
should be tested at least once a month.
Table of Contents