Multiquip MQ Power Duelweld Welder/Ac Generator BLW-400SSW - Manual (Page 6)

PAGE 6 — BLW-400SSW- WELDER/AC GENERATOR — PARTS & OPERATION MANUAL — REV. #1 (06/15/01)
RULES FOR SAFE OPERATION
Failure to follow instructions in this manual may
lead to serious injury or even death! This
equipment is to be operated by trained and
qualified personnel only! This equipment is for
industrial use only.
The following safety guidelines should always be used when
operating the BLW-400SSW Welder/AC Generator:
GENERAL SAFETY
■ DO NOT operate or service this equipment before
reading this entire manual.
■ This equipment should not be operated by
persons under 18 years of age.
■ NEVER operate this equipment without proper
protective clothing, welding shield, ventilator,
steel-toed boots and other protective devices
required by the job.
■ NEVER operate this equipment when not feeling
well due to fatigue, illness or taking medicine.
■ NEVER operate this equipment under the
influence or drugs or alcohol.
■ NEVER use accessories or attachments, which are not
recommended by MQ Power for this equipment. Damage to
the equipment and/or injury to user may result.
■ Manufacture does not assume responsibility for any accident
due to equipment modifications.
■ Whenever necessary, replace nameplate, operation and
safety decals when they become difficult read.
■ Always check the machine for loosened threads or bolts before
starting.
Always refuel in a well-ventilated area, away
from sparks and open flames.
Always use extreme caution when working with
flammable liquids. When refueling, stop the
engine and allow it to cool. DO NOT smoke
around or near the machine. Fire or
explosion could result from fuel vapors, or if
fuel is spilled on a hot engine.
■ NEVER operate the welder/AC
generator in an explosive atmosphere or
near combustible materials. An explosion or
fire could result causing severe
bodily harm
or even death.
■ Topping-off to filler port is dangerous, as it tends to spill fuel.
■ NEVER touch the hot exhaust
manifold, muffler or cylinder. Allow
these parts to cool before servicing
engine or welder/AC generator.
■ The engine of this welder/AC generator requires an adequate
free flow of cooling air. Never operate the welder/AC generator
in any enclosed or narrow area where free flow of the air is
restricted. If the air flow is restricted it will cause serious damage
to the welder/AC generator engine and may cause injury to
people. The engine gives off DEADLY carbon monoxide gas.
■ High Temperatures – Allow the engine to cool before adding
fuel or performing service and maintenance functions. Contact
with
hot components can cause serious burns.
CAUTION:
CAUTION :
Table of Contents