Metrologic Instruments MS7620 - Manual (Page 28)

25
C HANGING THE B EEPER T ONE & V OLUME
Changing the Beeper Tone
Beeper tones may be programmed directly or incrementally using the following
bar code. The new tone will be heard followed by a short pause. Two more new
tones will be heard signifying the new setting has been stored in memory. The
silent (no beep) tone is also selectable.
³ 9 9 9 9 7 5
Next Beep Tone
Changing the Beeper Volume
Volume levels may be programmed directly or incrementally using the following
bar code. The new volume will be heard followed by a short pause. Two more
tones will be heard signifying the new setting has been saved in memory. The
silent (no volume) tone is also selectable.
³ 9 9 9 9 7 4
Next Volume
These volume control and beeper tone bar codes can also be found under the
Top plate of the scanner and in the MetroSelect Programming Guide.
Figure 26: Additional Beeper Tone and Volume Control Bar Codes.