Multi-Tech Systems MT5600SMI-34 - Manual (Page 92)

Chapter 6 – Fax Class 1 and Class 1.0 Commands
Multi-Tech Systems, Inc. SocketModem MT5600SMI Developer’s Guide 92
Reporting Current or Selected Values:
Command: +FTM?
Response: +FTM: <mod>
Example: +FTM: 98 For V.17 9600 bps.
Reporting Supported Range of Parameter Values:
Command: +FTM=?
Response: +FTM: (<mod> range)
Example: +FTM: 3,24,48,72,73,74,96,97,98,121,122,145,146
Command: +FRM Receive Facsimile
Description: This command causes the modem to enter the receiver mode using the
modulation defined below.
Defined Values: <mod> Decimal number corresponding to the selected modulation mode and
data rates shown in Table 6-2.
Reporting Current or Selected Values:
Command: +FRM?
Response: +FRM: <mod>
Example: +FRM: 98 For V.17 9600 bps.
Reporting Supported Range of Parameter Values:
Command: +FRM=?
Response: +FRM: (<mod> range)
Example: +FRM: 3,24,48,72,73,74,96,97,98,121,122,145,146
Result Codes: CONNECT Reported when the selected carrier is detected.
+FCERROR Reported if another carrier is detected and FAR=0; the modem
then returns to the command state.
NO CARRIER Reported if loss-of-carrier is detected.
OK Reported if the DTE sends any character to the modem other than XON or
XOFF while operating in configured flow control from the DTE; the modem
then returns to the command state.
Command: FTH Transmit Data with HDLC Framing
Description: This command causes the modem to transmit data using HDLC protocol and
the modulation defined below.
Defined Values: <mod> Decimal number corresponding to the selected modulation mode and
data rates shown in Table 6-2.
Result Codes: CONNECT Reported for either of two conditions:
1. At the beginning of transmission of the training pattern for the selected
modulation.
2. If the Final Frame bit is 0.
OK Reported for either of two conditions:
1. If the Final Frame Bit is 1.
2. if the DTE sends only <DLE><ETX> (a null frame) while transmitting flags.
ERROR Reported if five seconds elapse from the time when the modem
reported the CONNECT result code without any additional data transmitted
from the DTE; the modem then turns off carrier and returns to the command
mode.
Reporting Current or Selected Values:
Command: +FTH?
Response: +FTH: <mod>
Example: +FTH: 98 For V.17 9600 bps.
Reporting Supported Range of Parameter Values:
Command: +FTH?
Response: +FTH?
Example: +FTH: 98 For V.17 9600 bps.