Commands and parameters, Mode entry commands, Mode commands – Multi-Tech Systems MT5600SMI-34 User Manual
Page 90: Mode entry commands mode commands
Chapter 6 – Fax Class 1 and Class 1.0 Commands
Multi-Tech Systems, Inc. SocketModem MT5600SMI Developer’s Guide
90
Commands and Parameters
Mode Entry Commands
+FCLASS=1 Select Facsimile Class 1 Mode
+FCLASS=1 selects the Fax Class 1 Mode. The Fax Class 1 Mode commands and responses described
in this section are applicable when command +FCLASS=1 as shown in Table 6-1.
+FCLASS=1.0 - Select Facsimile Class 1.0 Mode
+FCLASS=1.0 selects the Fax Class 1.0. The Fax Class 1.0 Mode commands and responses described
in this section are applicable when command +FCLASS=1.0 as shown in Table 6-1.
Mode Commands
Command:
+FAA
Auto Answer Enable - Class 1.0
Description:
This command enables or disables fax adaptive answer. This command
operates identically to the +FAE command.
Defined Values:
<value> Decimal number corresponding to the selected option.
0 Disable data /fax auto answer mode. (Default.)
1 Enable data /fax auto answer mode. The modem determines the calling
type and issues DATA result code (13) if the caller is a data modem or issues
FAX result code (15) if the caller is a fax modem.
Command:
+FAE
Auto Answer Enable - Class 1 and 1.0
Description:
This command enables or disables fax adaptive answer. This command
operates identically to the +FAA command.
Defined Values:
<value> Decimal number corresponding to the selected option.
0 Disable data /fax auto answer mode. (Default.)
1 Enable data /fax auto answer mode. The modem determines the calling
type and issues DATA result code (13) if the caller is a data modem or issues
FAX result code (15) if the caller is a fax modem.
After a data (not fax) connection is achieved (indicated by the DATA result
code), the DTE must issue an ATO command to cause the modem to go on-
line.
Command:
+FTS
Transmit Silence
Description:
This command causes the modem to terminate a transmission and wait for
<time> 10-ms intervals before responding with the OK result code.
Defined Values:
<time> Decimal number from 0 (default) to 255 that specifies the length of
time in 10-ms intervals to delay before responding with the OK result code
after terminating the session.
Result Codes:
OK Reported when transmission has been terminated for the specified
amount of time.
ERROR <value> is invalid or this command is issued while the modem is on-
hook.
Reporting Supported Range of Parameter Values:
Command: +FTS=?
Response: +FTS: <time> range
Example: +FTS: 0-255.