Document Outline

• Q_Dispenser_Cover_uc
  • Q Model Dispenser Installation Use and Care
    • Safety Notices
    • Procedural Notices
• Q_Dispenser_TOC_uc
  • Table of Contents
• Q_Dispenser_Section_1_uc
  • Section 1 - General Information
    • Model/Serial Number Location
    • Warranty Information
    • Equipment Overview
    • Room Key Card Activation
    • Coin Operated Activation
    • Adjusting the Coin Mechanism Timer
      • Canadian Coins
• Q_Dispenser_Section_2_uc
• Q_Dispenser_Section_3_uc
  • Section 3 – Installation Procedures
    • Installation Check List
    • Installation Procedures
    • Post-Installation Check List
• Q_Dispenser_Section_4_uc
  • Section 4 - Maintenance
    • Disassembling the Dispenser Parts
      • Door Removal
      • Removing the Drain Pan
      • Disassembling the Rocking Chute/Door
        • Re-Installing the Paddle Wheel Guard
    • Disassembling the Dispenser Parts for Bin Cleaning
      • Agitator and Paddle Wheel Removal
    • Removal of the Gearmotor
    • Monthly Sanitizing Procedure
• Q_Dispenser_Section_5_uc
  • Section 5 – Component Parts-Removal and Replacemet
    • Gearmotor Shaft Seal Replacement
• Q_Dispenser_Section_6_uc
  • Section 6 – Checklist
    • Problem: Ice Does Not Dispense When Rocking Chute is Depressed6-1