Minuteman UPS MCP-E - Manual (Page 7)

6
R EAR P ANEL (120Vac models shown)
I NSTALLATION P LACEMENT
Install the UPS in a temperature controlled environment that is free of conductive contami-
nants. Select a location which will provide good air circulation for the UPS at all times.
Avoid locations near heating devices, water or excessive humidity, or where the UPS is
exposed to direct sunlight. Route power cords so they cannot be walked on or damaged.
Operating Temperature: 700VA-5000VA: 0 to 40
°
C, 7000VA: 0 to 32
°
C
Storage Temperature: -15 to +45
°
C Operating Elevation: 0 to 3,000 Meters
Storage Elevation: 0 to 15,000 Meters Operating and Storage Relative Humdity: 95%,
non-condensing
Tower Models
1. Smart slot for optional cards
2. Switch, momentary switch used to
change displays or silence alarm
3. Dip switches used to configure unit
parameters
4. Simple Communications port (AS400)
5. RS232 intelligent communications port
6. Network protection (lan only)
7. External battery connection point
8. Output load receptacles
9. Output load circuit breakers
10. Incoming utility power cord
11. Incoming utility circuit breaker
Rackmount Models
1. Incoming utility power cord
2. Incoming utility circuit breaker
3. External battery connection point
4. Network protection (lan only)
5. Smart slot for optional cards
6. Switch, momentary switch used to change
displays or silence alarm
7. Dip switches used to configure unit
parameters
8. Simple Communications port (AS400)
9. RS232 intelligent communications port
10. Output load circuit breakers
11. Output load receptacles
English
INSTALLATION