Problems and causes, Figur – Mr. Coffee ECMPl User Manual
Page 8

2.
Then immerse the frothing tube into the milk.
Start generating steal,. by
turning the steam selector control knob upwards. A 15-30 second delay
may occur.
Note:A little water will first escape from the frothing
FIGUR
tube. This will not harm the frothed milk In any way.
3 .
4 .
5.
Immerse the frothing tube only about half way into
the liquid, so that the flow of air Is not hlndered.
The frothing tube should not be allowed to touch
the base of the container as this mlght restrict the
outflow of steam. Frothed milk will resemble a
whlpped cream texture. Sea flgun 4.
To stop the flow of steam, turn the steam control
knob downward back to the OFF position.
Afterwards, turn the frothing tube as far as it will go
to the left so that the last few drops of liquid can fall
into the drip grate.
Note: Frothing aid may shut off when you prepare froth for two cups of
capcappuccino. Just restart the machine by turning on the on/off
switch.
After steaming, the following steps are necessary:
1.
Put the filter holder and filter basket (but without coffee) In the brew
head
Place an empty cup or frothing pitcher under the filter holder.
t
Turn the ON/OFF swith ON, until approximately 3 ounces of water flows
out of he filter holder. Then tur n the ON/OFF switch
OFF.
Remove filter holder. Make sure the steam selector control knob is
in the OFF position.
Problems and Causes
. ..the espresso temperature Is too low
l
Tamp the espresso ground coffee down a little more firmly.
l
Pre-warm the cups by rinsing them in warm water. (See page 11).
l
Delime the appliance.
. . the
flow-through speed of the espresso
falls off noticeably
l
Do not tamp the espresso ground coffee down so firmly.
l
Delime the appliance.
. .the espresso runs out at the side of the filter holder
l
Make sure the filter holder is fitted into the holding ring properly.
l
Tighten the filter holder a little more firmly into the holding ring.
l
Clean the espresso ground coffee off the edge of the filter holder.
l
Clean the brew head. (See page 10).