Miele GAS KM 81-2 - Manual (Page 32)

@ä
Instructions for building-in
Stick the seal provided f
under the
edge of the cooktop.
b Appliance
c Tensioning screw
d Clamp
e Worktop
f Seal
Turn the tensioning screws
c
in the
clamps in an anti-clockwise direction
into the appliance
b
until a resist-
ance is met and turn the clamp to
the left.
Place the appliance into position,
turn the clamps and tighten the ten-
sioning screws until the clamps
press into the worktop
e
.
Connect the appliance to the elec-
tricity supply.
Connect the appliance to the gas
supply in accordance with gas sup-
ply regulations.
When building-in several Combiset
units, a spacer bar must be fitted be-
tween each unit. It is supplied with its
own installation instructions.
loosen tighten
Depth
in
mm
Width
(=
Dimen-
sion B)
in mm
2 zone Combiset
1 element
2 elements
3 elements
4 elements
5 elements 490
490
490
490
490 265
558
851
1144
1437
4 zone Combiset
1 elements
2 elements
3 elements 490
490
490 560
1143
1728
Combination
One 2 zone
+ one 4 zone
Two 2 zone
+ one 4 zone
Three 2 zone
+ one 4 zone
One 2 zone
+ two 4 zone
Two 2 zone
+ two 4 zone
490
490
490
490
490
851
1143
1437
1436
1729
Extractor (e.g. DA 8-2)
For building in between two appliances:
-
Dimension B increases by 90 mm.
For building in at the end of a combination:
-
Dimension B increases by 98 mm.
@ä
Instructions for building-in
32