Miele GAS KM 81-2 - Manual (Page 8)

Warning and Safety Instructions
Check that all the burners are cor-
rectly assembled before igniting
the gas, otherwise the ignition could
malfunction.
Please note the following, in case
unit is on LPG supply:
Where this appliance is installed in
marine craft or in caravans, it shall
not be used as a space heater.
Wall sealing strips must be heat-
resistant and any backmoulding
must be of heat resistant material.
The minimum clearances (USA/CDN):
from adjacent combustible construc-
tion – 10" (250 mm),
between appliance and rear wall or
front of backsplash – 90 mm (CDN)
or 3 1/2" (USA),
between appliance and overhead
combustible construction
– 30" (760 mm) or
65 cm (26") between the cooktop
and a cooker hood above it,
between appliance and front edge of
countertop – 2 1/4" (55 mm),
depth of overhead cabinets must not
exceed – 13" (330 mm),
between combustible constructions
and the extending cooking surface
– 460 mm (Canada).
The minimum clearances (AUS/NZ):
When installing the gas cooktop,
the following minimum dimensions
must be kept.:
See "Clearance above and around
the appliance" (pages 27 – 31),
60 cm between the cooktop and a
cooker hood above it.
Leave these instructions with the
consumer.
Important notes for the user
For safety reasons, this cooktop
should only be installed as a built-
in appliance.
Do not let small children use the
appliance or touch it during oper-
ation. Not only do the cooking areas
heat up, but also the control panel.
Danger of burning. Keep all pans out of
the reach of children. Supervise use of
the cooktop by the elderly or infirm.
Warning and Safety Instructions
8