Mitel SIP USER AND ADMINISTRATOR GUIDE 5320 - Manual (Page 29)

5320/5330/5340 IP Phone SIP User and Administrator Guide
23
Add a Party On Hold to a Call in Progress
1. Press (TRANS/CONF). The current call is put on hold.
2. Press the Line key of the party already on hold.
3. Press (TRANS/CONF). The call put on hold in step 1 is connected to the call in
progress.
Leave a Conference Call
Do one of the following:
• Hang
up.
• Press (CANCEL).
Note: If any party in a conference call hangs up, the other parties remain connected.
Return to a Conference Call after Accepting an Outside Caller
If the originator of a conference responds to a call from another party during a conference, the
other two conference members are put on hold.
To resume the conference, the originator must:
1. Select one of the held lines and then press (TRANS/CONF).
2. Select the remaining held line and then press the Conf softkey.
Messages - Advisory
An advisory message about your whereabouts appears on your caller's display.
Create an Advisory Message
• Access the Feature Configuration page of the Web Configuration Tool (see Accessing the
Web Configuration Tool on page 10).
Enable/Disable your Advisory Message
To enable or disable an advisory message:
1. Press MENU , and then press >> until Features? appears.
2. Press OK, and then press Next or Prev until ADVISORY MESSAGE? appears.
3. Press OK. The first of several advisory messages appears.
4. Press (UP) or (DOWN) to navigate to the desired message.
5. Press TurnOn or TurnOff to enable or disable the message. When enabled, the Advisory
Message appears in the information area of the phone display.