Maytag GEMINI - Manual (Page 15)

14
LOWER OVEN LIGHT
(
SELECT MODELS
)
TO REPLACE OVEN LIGHT BULB:
1. When oven is cool, hold bulb cover in
place, then slide wire retainer off cover.
NOTE: Bulb cover will fall if not held in
place while removing wire retainer.
2. Remove bulb cover and light bulb.
3. Replace with a 40-watt appliance bulb.
4. Replace bulb cover and secure with wire
retainer.
5. Reconnect power to range. Reset clock.
➢ Disconnect power to range before
replacing light bulb.
➢ Use a dry potholder to prevent pos-
sible harm to hands when replacing
bulb.
➢ Be sure bulb is cool before touching
bulb.
➢ Do not touch hot bulb with a damp
cloth as this may cause the bulb to
break.
BULB COVER
WIRE
RETAINER
UPPER AND LOWER OVEN
LIGHTS (
SELECT MODELS
)
To assure the proper replacement bulb is
used, order bulb from Maytag Customer
Service. Call 1-800-688-8408, ask for part
number 74004458 - halogen bulb.
➢ Disconnect power to range before
replacing light bulb.
➢ Allow oven to cool before replacing
light bulb.
➢ Make sure bulb cover and bulb are
cool before touching.
TO REPLACE OVEN LIGHT BULB:
1. When oven is cool, use fingertips to grasp
edge of bulb cover. Pull out and remove.
2. Carefully remove old bulb by pulling
straight out of ceramic base.
3. To avoid damaging or decreasing the life
of the new bulb, do not touch the bulb with
bare hands or fingers. Hold with a cloth or
paper towel. Push new bulb prongs
straight into small holes of ceramic base.
4. Replace bulb cover by snapping into place.
5. Reconnect power to the range. Reset
clock.
ELECTRICAL
CONNECTION
Appliances which require elec-
trical power are equipped
with a three-prong
grounding plug which
must be plugged directly
into a properly grounded
three-hole 120 volt electrical outlet.
Always disconnect power to appliance be-
fore servicing.
The three-prong grounding plug offers pro-
tection against shock hazards. DO NOT CUT
OR REMOVE THE THIRD GROUNDING
PRONG FROM THE POWER CORD PLUG
If an ungrounded, two-hole or other type
electrical outlet is encountered, it is the per-
sonal responsibility of the appliance owner
to have the outlet replaced with a properly
grounded three-hole electrical outlet.
OVEN BOTTOM
Protect oven bottom against spillovers, espe-
cially acidic or sugary spills, as they may dis-
color the porcelain enamel. Use the correct pan
size to avoid spillovers and boilovers. Do not
place aluminum foil directly on the oven
bottom.
CAUTION
CAUTION