Marantz SR6400 - Manual (Page 12)

9
ENGLISH
3. Close the cover until it clicks.
Note:
• The supplied batteries are shipped to confirm the
initial operation. Therefore, the supplied batteries
will be consumed quickly.
REMOTE CONTROL RANGE
The distance between the transmitter of the
remote control and the IR SENSOR of the SR6400
should be less than 5 meters. If the remote control
is pointed in a direction other than the IR SENSOR
or if there is an obstacle between them, use of the
remote control may not be possible.
Remote-controllable range
LOADING BATTERIES
The life of the batteries used with the remote control
is about 4 months with normal use. Also be sure to
replace batteries earlier when you notice that they
are getting weak.
1.
Remove the back cover.
2.
Insert the new batteries (AA type) with correct
(+) and (–) polarity.
Remote control unit (RC7300SRa)
60 °
SR6400
Approx. 5 m
GENERAL INFORMATION OF
RC7300SRa TO SR6400
To control the SR6400 by your RC7300SRa, you
have to select the device AMP or TUNER by
pressing the function selector button. Please refer
below for the details in AMP and TUNER mode.
POWER ON/OFF Turns the SR6400 on and off
POWER ON
Turns the SR6400 on
POWER OFF Turns the SR6400 off
V-OFF Turns on or off the Video OFF mode
EQ Turns on or off the HT-EQ mode
7.1/6.1 IN Selects the 6.1CH IN
SLEEP Sets the sleep timer function
A/D Switches between the analog and digital inputs
DISP./RDS Changes the front display mode
Surround mode Selects the surround mode
(0-9) * DSP button is unavailable to SR6400.
S-DIRECT Selects the Source Direct mode
NIGHT(+10) Turns on or off the NIGHT mode
MUTE Decreases the sound temporarily
BASS 34 Adjusts the tone control of low frequency sound
TREBLE 34 Adjusts the tone control of high frequency sound
VOL 34 Adjusts the over all sound level
MENU/OSD Displays the current setting on the monitor
Cursor Moves the cursor for settings in the “On screen display” mode
OK • Enters the “On screen display”
•Confirms the settings in “On screen display” mode
SETUP Same as the OK button
CH SEL Calls up SETUP MENU and adjusts speaker levels or 6.1ch input level
TEST Enters the test tone menu
EXIT Exits from the SETUP MAIN MENU
SPKR A/B Selects the speaker system
ATT Reduces the input level
Function selector Selects a particular source component
TUNER MODE
AMP MODE
0-9 Inputs the numeric #s
DISP./RDS Selects the display mode in RDS (*)
F.DIR/SEAR Selects the “Frequency direct input”
PTY Displays the programmed information of the current station (*)
MEMO Enters the tuner preset memory numbers
CL Clears the inputting
T.MODE Selects the auto stereo mode or mono mode
P.SCAN Starts preset scan
CHANNEL/SKIP • Selects a preset station
• Changes a PTY type
TUNE/SEARCH Tunes a station
TUNER Selects a frequency band
(*): European model only