MITSUBISHI ELECTRIC TG-2000A - Manual (Page 33)

30
Change the unit configuration.
[Procedure]
1) Select the G-50 No. with the “ / “ buttons.
In this case, use the “ / “ buttons to select the G-50A No. desired to change the unit
configuration.
2) Delete/add the unit icon.
Unit icon deletion: Click the unit icon to be deleted.
Unit icon addition:Click the unit icon to be added from the selected unit icon column to set it to
the selected state.
(The symbol of the selected unit is displayed by the pointer.)
When the address column to be added is clicked, the unit icon is displayed.
Table: Icon symbol and unit name
Icon Name Address range
IC Indoor unit
LC LOSSNAY
FU OA processing unit
KIC “K” Control Units
AIC “A” Control Units
1 to 50
OC Outdoor unit
B C B C controller (master)
B S BC controller (slave)
OS Subsidiary outdoor unit
51 to 100
RC ME remote controller (compact remote controller) /
LOSSNAY remote controller 101 to 200
S C System controller (Including GR, SR, and AN)
GR Group remote controller
S R System remote controller
A N On/Off controller
201 to 250
K A K -transmission converter (201 to 250)
TR Central controller (MJ-103) (201 to 250)
G-50 Central controller G-50 (0, 201 to 250)
?? Unconfirmed unit (1 to 250)
3) Select the [OK] button.
After fully completing the unit icon change, click the [OK] button.
Note:
• When the system information is collected from the G-50A, all the SR, GR, and AN display "SC".
It is possible to change the icon to that of the system controller actually connected. When the
icon is changed, it is possible to display the unit in which the error occurred with the type easily
discriminated.
• Delete the "??" icon displayed, and set the original icon. Note that it is unable to advance to the
next step if the "??" icon exists.