MITSUBISHI ELECTRIC TG-2000A - Manual (Page 60)

57
3) Click the indoor unit icon.
Select the icon of the unit to be displayed or changed.
The “indoor unit data maintenance” screen appears.
4) Select the proportional division parameter.
Select the cell of the proportional division parameter
to be changed (regular hours, off hours).
The cursor appears in that cell.
5) Make changes to the data.
Enter the changes to the apportioned data (for each
time slot).
<Correction method>
Click the cell of the proportional division parameter to be changed.
When the cell is clicked to be selected, the “ / ” button is displayed in the cell. Click the “ / ” button to
correct the data. (The numeric value can also be directly input with the keyboard.)
When the [Corrective calculation] button located in the lower part of the screen is clicked after correcting
the data for all dates or at the halfway point of correcting the data, the results of the air-conditioning block
charge, calculated in accordance with the corrected data, is displayed together with the pre-correction
total proportional division parameter. It can be used as a guideline for data correction.
<Caution>
• The value calculated using the [Corrective calculation] button is a temporarily calculated
value. To reflect it in the air-conditioning charge, recalculate on the air-conditioning charge
screen after correcting the data for all indoor units.
• The apportioned electric power and proportional division parameters are displayed or input
up to one digit after the decimal point. The display value is rounded at the 2nd digit after
the decimal point.
[Unit Data Display Colors]
Black : Normal
Red
: Abnormal
Blue : Maintenance
Green : Un-apportioned data
Gray : No data
[Time zone]
Within (day) : Regular hours
Outside (night) : Off hours
Indoor Unit Data Maintenance screen
Proportional division parameter
Recalculation button
[Without WHM connection]
Charge data maintenance screen
(display of indoor unit icon)
Indoor unit icon