Memorex MVDP1077 - Manual (Page 15)

14
CONNECTION (CONTINUED)
CONNECTING THE UNIT TO A HOME THEATER SYSTEM (COAXIAL JACK)
From S-VIDEO
OUT Jack
From COAXIAL OUT Jack
NOTES FOR CONNECTING TO A HOME THEATER SYSTEM:
• Set the TV’s TV/VIDEO button or switch to the VIDEO setting.
• When connecting the
unit , refer to the owner’s manuals for the TV and the audio
system, as well as this manual.
• When connecting, make sure the power is off and all units are unplugged before making
any connections.
• Connect the unit to your TV directly. If you connect the unit through a VCR, the playback
picture will be distorted because DVD video discs are copy protected.
• Set the Audio Out on the Audio Setup menu to SPDIF/PCM, see page 20.
• If your TV does not have S-Video input, use the included A/V cable and connect the
Video OUT (yellow color end of the cable) to your TV's Video IN jack.
Place the subwoofer, front, rear and center
speakers in locations as shown/described
here. After correctly positioning the
speakers, perform the Tone Test on the AV
Amplifier and adjust the Volume control(s)
until the desired sound is achieved. For best
results, sit in the viewing position and have
someone adjust the volumes for you; this will
enable you to set the optimal levels.
NOTE: The rear speakers can also be
located on the side wall facing the viewing
position and each other. Make sure the
viewing position is located between the two
speakers in this case. Experiment to find
optimal position.
1. Front Left Speaker
2. Television
3. Center Speaker–can be located on top or
below the Television.
4. Sub-woofer–can be located anywhere in the
room.
5. Front Right Speaker
6. Viewing/Listening Position–The best
listening position is obtained by positioning the
chair, sofa, etc. in the middle of all the
speakers.
7. Rear Left Speaker
8. Rear Right Speaker
9. AV Amplifier w/Dolby Digital Decoder