Memorex MVDP1077 - Manual (Page 9)

8
POWER SOURCES (CONTINUED)
BATTERY PACK INSERTION/REMOVAL
Follow the diagram below to insert or remove the Battery Pack.
CHARGING THE BATTERY PACK
The Low Battery indicator will blink at the top left-hand corner of the screen when
the Battery Pack is low and needs recharging. With the Battery Pack attached to
the unit, insert the small end of the AC adapter into the DC IN jack on the side of
the unit. Insert the other end (with the 2 blades) into a conveniently-located AC
outlet having 120V AC, 60Hz. The CHARGE indicator on the Battery Pack will blink
red as the Battery Pack is charging and light solid red when charging has
completed. Remove both the DC plug and the AC-IN plug to disconnect the AC
adapter when charging has finished.
NOTES:
• Fully charge the Battery Pack for 12 hours before using it for the first time. After
the initial charge, it should take approximately four hours to charge.
• A fully-charged Battery Pack can operate for about 2 and a half hours.
TO REMOVE: Press down the Battery
Release button on the rear of the Battery
Pack, then slide the Battery Pack out towards
the rear of the unit.
TO INSERT: Align the tabs from the Battery
Pack into the holes on the middle of the main
unit. Then, slide the Battery Pack into the
main unit until it clicks into place.
2 1