Marantz VC5400 - Manual (Page 9)

9
INTRODUCTION
Rear Panel
Caution
Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent
damage to the unit.
COAXIAL (Digital audio out jack)
Connect to digital (coaxial) audio equipment.
OPTICAL (Digital audio out jack)
Connect to digital (optical) audio equipment.
AUDIO OUT (Left/Right)
Connect to an amplifier, receiver,
or stereo system.
VIDEO OUT
Connect to a TV with video inputs.
AC Power Cord
Plug into the power source.
S-VIDEO OUT
Connect to a TV with S-Video inputs.
COMPONENT VIDEO OUT (Y, C B /P B , C R /P R )
Connect to a TV with Y, C B /P B , C R /P R inputs.
5.1 CHANNEL AUDIO OUT
Connect to a 5.1 channel receiver
– center speaker connection
– subwoofer connection
– front speakers connections
– rear (surround) speakers connections
**REMOTE CONTROL
EXTERNAL/INTERNAL
Switch
RS232C Terminal
Control terminal for use by
custom installers.
* REMOTE CONTROL IN/OUT jacks
By connecting this DVD player to another Marantz audio component using a supplied System Control cable, you
can remotely operate the components as a single system.
• When connecting to component with a remote sensor, be sure to connect the “REMOTE CONTROL IN” jack of
this DVD player to the “REMOTE CONTROL OUT” jack of the component with the remote sensor.
• When connecting to component which is not equipped with a remote sensor, be sure to connect the component to
the “REMOTE CONTROL OUT” jack of this DVD player.
** Remote switch
• When using this DVD player independently, set this switch to “INTERNAL”. When using this DVD player in a
system with a Marantz receiver equipped with a remote sensor, set the switch to “EXTERNAL”.
* REMOTE CONTROL IN/OUT jack