Motorola WE800G - Manual (Page 23)

SECTION 2 INSTALLATION
2-6 SECTION 2, INSTALLATION
Electrical Connection to Wireless Ethernet Bridge
Your Wireless Ethernet Bridge does not have an On/Off power switch
and will only be powered on by plugging in the power adapter. To
make the electrical connection to the Wireless Ethernet Bridge:
CAUTION!
Use only the Motorola supplied WE800G power adapter.
1 Connect the power adapter to the Wireless Ethernet Bridge’s
Power port, found on the back of the unit:
To power
supply (5V / 2A)
2 Plug the power adapter into a grounded and surge protected
power outlet. The Power LED on the front panel lights green
when connected properly.