Mocomtech CRS-300 - Manual (Page 191)

CRS-300 1:10 Redundancy Switch Revision 16
Front Panel Operation MN/CRS300.IOM
7–11
7.4.4 CONFIG: REMOTE
SELECT REMOTE CONTROL:
LOCAL REMOTE (PRESS ENT)
Select LOCAL or REMOTE using the ◄ ► arrow keys, then press [ENT] .
CONFIG: REMOTE Æ LOCAL
If LOCAL is selected, remote control will be disabled, though remote monitoring is always
possible.
CONFIG: REMOTE Æ REMOTE
If REMOTE is selected:
REMOTE CONTROL: BAUDRATE
INTERFACE (PRESS ENTER)
Select BAUDRATE or INTERFACE, using the ◄ ► arrow keys, then press [ENT] .
CONFIG: REMOTE
Æ REMOTE Æ BAUDRATE
If BAUDRATE is selected:
EDIT SWITCH BAUDRATE:
19200 BAUD (PRESS ENT)
The User may select the baud rate of the remote control bus, connected locally to the M&C
computer. Change the value by using the ▲ ▼ arrow keys. Values of 300, 1200, 2400, 4800,
9600 and 19200 baud are possible.
Once baudrate has been set, the User should pres ENT.
Note: This setting does not affect the internal communications between the Switch and the modems.
CONFIG: REMOTE Æ REMOTE Æ INTERFACE
If INTERFACE is selected:
ELECT. INTERFACE: RS232
RS485-2W RS485-4W (ENT)
Select RS232, RS485-2W (2-wire), or RS485-4W (4-wire) using the ◄ ► arrow keys, then press
[ENT] . The User will be further prompted to enter the bus address.
In this example, RS-232 mode is used and the bus address is fixed at 0:
IN RS232 MODE THE BUS
ADDRESS IS FIXED AT 0000
If in RS-485, the address may be selected. The valid addresses are 1000, 3000, 5000 and 7000
only, as explained in
Appendix C. REMOTE CONTROL in this manual.