Marantz RC9500 - Manual (Page 23)

User Guide
19
Customizing your RC9500
7 Switch back to DELETE mode and delete the device if it is not a
good match to your component. Repeat steps 4 through 7 until
all of your remote controls have matching devices.
8 Switch to LABEL mode to relabel each device.
(see page 32)
9 Switch to MOVE mode to re-order your devices, so that your
Device Overview page is arranged the way you want.
(see page 41)
10 Switch to LABEL mode to relabel any buttons as needed to
match your existing remote controls. Check all of your devices.
12 Switch to LEARN mode and learn all of your non-Marantz
components’ RC Codes to the RC9500. (see page 28)
13 Switching back and forth between USE and LEARN modes, test
all codes and reteach as necessary.
Note Be very careful to NEVER delete the
Jump tabs; they can only be restored
with the editor software using a PC.
(see page 56)
14 Switch back to LEARN mode. Learn the appropriate
Preamp/Receiver Input (source switching) IR command to each
Device as the Device Action. (see page 30)
Congratulations!
You have completed the first stage of customization.
Take a well deserved break.
DFU RC9500 Ver1_2.qxd 5/28/2004 10:33 AM Page 23