Marantz RC9500 - Manual (Page 35)

User Guide
31
Reference
Notes · It is possible to teach commands to the LEFT (labeled “Back”)
and RIGHT (labeled “Ahead”) Function buttons on the remote.
But those commands can be re-programmed only via a PC
using the editor software.
· It is not possible to teach commands to the HOME button on
the remote. Unless those commands were re-programmed via a
PC using the editor software.
· When the Cursor Navigation is active, the 4-way cursor buttons
cannot be learned.
Hard buttons can be programmed for a device specific command
for a particular device on the remote (Programming locally).
1 Switch to the device for which you want to program the button.
2 Complete steps 1 to 9 in the programming Touch Screen
buttons on page 29. Instead of tapping a button on the Touch
Screen, press the hard button you want to program.
Note Only via PC, hard buttons can be programmed with a global
function for all devices (Programming globally).
When a command is learned to a hard button to a device page,
it will only be issued when that device is active, even if a command
has been programmed globally. Local learning overrides global
programming.
For example:
One could program the CH+ & CH- buttons as the Chapter +/-
command when the DVD is active. Now, if you program the TV channel
+/- globally (and any device other than the DVD is selected) the TV
channel +/- commands will be issued.
DFU RC9500 Ver1_2.qxd 5/28/2004 10:33 AM Page 35