Marantz RC9500 - Manual (Page 63)

User Guide
59
Troubleshooting
General Problems
The display is blank
„
Tap the screen to make sure the RC9500 is turned on.
„ Adjust the screen brightness using the buttons on the left side.
(page 17)
„
Make sure the battery pack is properly installed. (page 4)
„ Recharge the battery pack using the docking station. (page 5)
The display is too light or too dark
„ Adjust the screen brightness using the buttons on the left side.
(page 17)
The RC9500 shuts itself off
„ This is a feature of the RC9500 to save power. You can change
the length the RC9500 stays on in the Setup. (page 13)
Devices do not respond to commands from the RC9500
„ Make sure the RC9500 is in USE mode. (page 7)
„
Make sure the RC9500’s IR sending eye is pointed towards the
device you’re operating.
„ Check if the Low Battery icon appears. If so, recharge the
battery pack using the docking station. (page 5)
„
Check if the button you are trying to use is programmed
properly. (page 18)
„
Check if your device understands these particular Marantz
infrared codes. Re-add the device with the correct model
number. (page 35)
DFU RC9500 Ver1_2.qxd 5/28/2004 10:33 AM Page 63