Motorola Canopy Powerline MU - Manual (Page 36)

Powerline MU
Page 36 of 112
6 CONFIGURING THE POWERLINE MU GATEWAY
You must configure the Powerline MU Gateway and Modems for your system. For
easiest setup, configure the components before they are installed.
Gateway Configuration Interface Map
System
System Info
Date and Time
Password
Logs
Reboot
Backup
Site Info
Advanced
BAM Configuration
SNMP Configuration
SNMP Access Control
VLAN Configuration
IP Address
IP Configuration
Powerline
Modem List
NEK Configuration
PSD Settings
Remote NEK
6.1 CONNECT TO THE GATEWAY
To connect to the gateway, use a PC or laptop with a web browser.
Set a static IP address on your Laptop to 192.168.1.97. You may have to temporarily
disable anti-virus software or disable the proxy settings in your computer.
Using a standard CAT-5 Ethernet cable, connect your PC or laptop to one of the
numbered Ethernet ports on the front panel of the gateway. (see Figure 15).
Figure 15 Gateway connected to laptop