Meridian America Digital Audio Processor Meridian 518 - Manual (Page 23)

Customise 518 using Type 23
518 User Guide
Caution Some power amplifiers are very susceptible to small surges that
may result from the process of switching a preamplifier on and off. Some
– like the Meridian
205 or 605 incorporate DC-offset protection that may
be triggered by this process. Meridian active or digital loudspeakers are
inherently proof against these surges and need not be switched off. In
general digital products like power amplifiers, recorders etc. will be
unpredictable when they have the digital signal interrupted.
How to change back to Normal
To revert to Normal .
1. Switch off the 518 using the power switch on the back.
2. After half a second, switch the 518 power on again.
Making changes to an existing setup
Config is a configuration editing mode, it does not reset on entry. Type
however performs a full reset of all parameters.
To make any changes to your custom configuration:
1. Change to Config,
2. make the changes you want,
3. change back to Normal.
Customising using Type
Type is a mode used specifically to setup 518 into one of three factory-
preset configurations.
•
Type resets the following for all three Types.
Setting Type 0 Type 1 Type 2
Controller Auto Auto N.Con
System Address 1 1 1
Product Address 1 1 1
Standby Y Y N
Bypass N Y Y
Blank Y Y N
*Emph N N N
Volume M N N
Volume ## dB dB