Customising using config, How to use config – Meridian America Digital Audio Processor Meridian 518 User Manual
Page 24
Customise 518 using Type
24
518 User Guide
•
Source-Logo-input mapping as shown below.
Source
Logo
Type 0
Input
Type 1
Input
Type 2
Input
Comms
type
CD
CD
D1
D1
D1
1
Radio
RD
D1
D1
N
2
LP
LP
D1
D1
N
–
TV
TV
D1
D1
N
–
Tape1
T1
D2
D1
D2
–
Tape2
T2
D3
D1
D3
–
CDR
CR
D1
D1
N
–
Cable
Cb
D1
D1
N
–
Text
Tx
D1
D1
N
–
VCR1
V1
D1
D1
N
–
VCR2
V2
D1
D1
N
–
LD
LD
OP
D1
OP
–
Selecting Types
1. Switch off any power amplifiers that are connected to the system.
2. Switch off the 518 using the power switch on the back.
3. While pressing the Off key on the 518 front panel, switch the power on
again. The display will read:
4. Release the Off key
5. Use the front-panel and Volume keys to move the selection
between Types 0 – 2.
6. When you have the Type you want displayed, wait one second for 518
to action the choice.
7. Switch off the 518 using the power switch on the back.
8. After half a second, switch the 518 power on again to restore Normal
mode.
Customising using Config
In Config you can review and change settings to do with communications,
control and the hardware options you have. In Config you also make
choices about the number and types of sources, what the display shows
when you select them etc. The 518 is initially programmed to Type 1 and
all Types set up the source configuration as shown in the previous Tables.
How to use Config
1. Switch off any power amplifiers that are connected to the system.
2. Switch off the 518 using the power switch on the back.
3. While pressing the Display key on the 518 front panel, switch the
power on again. The display will read:
4. Release the Display key, the display will show:
Type
1
Config