Meridian America Digital Audio Processor Meridian 518 - Manual (Page 25)

Customising 518 using Config 25
518 User Guide
Selecting the controller mode
In Config mode:
1. Press Display until you see a display like:
2. Use the and , Volume keys to choose between:
•
Auto, meaning configuring can be automatic
•
Cont, meaning the 518 will be the system controller
•
N.Con, meaning the 518 will not be the controller
Setting the system address for 518
In Config mode:
1. Press Display until you see a display like:
This means the system address is 1. The Meridian 500 Comms system
allows for up to eight systems operating on the same network. Unless you
are setting up a Multiroom system, or are advised to do so by Meridian
support personnel, we suggest you leave this on address 1.
Setting the product address for 518
In Config mode:
1. Press Display until you see a display like:
This means the product address is 1. The Meridian 500 Comms system
allows for up to eight products of the same type operating on the network.
Unless you are setting up a Multiroom system, or are advised to do so by
Meridian support personnel, we suggest you leave this on address 1.
Note When customisation is complete, switch the power off and then on
again to restore Normal mode and to save what you have done.
Setting the Standby mode for 518
In Config mode:
1. Press Display until you see a display like:
This means that Standby mode is available. To prevent Standby chose N.
2. Use the and , Volume keys to choose between Yes or No.
Setting the Bypass option for 518
In Config mode:
1. Press Display until you see a display like:
This means that Bypass is available. Bypass prevents the 518 operating
as a volume control and is therefore it is highly undesirable to access it by
mistake if you are using 518 to control volume.
2. Use the and , Volume keys to choose between Yes or No.
Auto
Auto
SA=1
PA=1
Stby Y
Bypass Y