Moyer Diebel MH-60M5 - Manual (Page 20)

INITIAL START-UP
12
Check Wash
Water Temperature
The wash tank heater and the (booster tank
heater, MH-60 only) will begin to heat the
water in the dishwasher.
Wait approximately 10 minutes for the wash
tank water to reach operating temperature.
The temperature should be a minimum
of 150°F/66°C for (MH-60, MH-6N).
The MH-6L requires a minimum of
120°F/49°C. However, a minimum of
140°F/60°C is optimum for the MH-6L.
Prescrap the dishes. Load ware into the
dishrack. Open the doors, insert the rack
into the dishwasher.
Note that the power indicator light
is illuminated.
THE POWER SWITCH IS
ON DURING INITIAL FILL.
Make sure the doors are fully closed.
Push the On/Off power switch to the
UP position.
THE DISHWASHER FILLS
AUTOMATICALLY.
NOTE:
The dishwasher will fill automatically
each time the power is turned off even
if the dishwasher is full of water.
3
4
INITIAL START-UP
(CONT.)
WASH
EXTENDED WASH
CYCLE
POWER
OFF
RINSE PRESSURE
WASH
EXTENDED WASH
CYCLE
POWER
OFF
RINSE PRESSURE
WASH
EXTENDED WASH
CYCLE
POWER
OFF
RINSE PRESSURE 5