Multi-Tech Systems FR3060 - Manual (Page 14)

14
MultiFRAD 3000-Series User Guide
Introduction
This chapter guides you through the unpacking and installation of your MultiFRAD. The
installation procedure, provides step by step instructions on cabling and powering-on the
MultiFRAD. Chapter 3 provides instructions on loading and configuring the MultiFRAD software.
Unpacking your MultiFRAD 3000
Remove all items from the box. Your shipping box should contain the MultiFRAD, a power
supply, cables, software and manual diskettes, and a MultiFRAD 3000-Series Quick Start Guide.
Inspect all items before proceeding with the installation. If any of the items appears to be
damaged in any way, do not power up the unit; contact Multi-Tech’s Technical Support personnel
for advice (See Chapter 6). If no damage is observed, configure the MultiFRAD using the
information in this chapter.
3000-Series Router/Multiport Data/Voice/Fax Frame Relay Access Device
Voice/Fax Channel 8 Voice/Fax Channel 7 Voice/Fax Channel 6 Voice/Fax Channel 5
Voice/Fax Channel 4 Voice/Fax Channel 3 Voice/Fax Channel 2 Voice/Fax Channel 1 XSG RSG XMT RCV E&M FAX FXS FXO
XSG RSG XMT RCV E&M FAX FXS FXO
XSG RSG XMT RCV E&M FAX FXS FXO XSG RSG XMT RCV E&M FAX FXS FXO XSG RSG XMT RCV E&M FAX FXS FXO
XSG RSG XMT RCV E&M FAX FXS FXO XSG RSG XMT RCV E&M FAX FXS FXO XSG RSG XMT RCV E&M FAX FXS FXO
Composite Link Ethernet Channel 1 Channel 2 Channel 3 Channel 4 Channel 5 Channel 6 Channel 7 Channel 8 Channel 9 Channel 10 XMT RCV XMT RCV XMT RCV XMT RCV XMT RCV XMT RCV XMT RCV XMT RCV BTG PWR LNK EXT V35 CTS CD XMT RCV XMT RCV COL LNK XMT RCV V35 XMT RCV V35
Figure 2. Unpacking
Safety Warnings
1. Never install telephone wiring during a lightning storm.
2. Never install a telephone jack in wet locations unless it is specifically designed for wet locations.
3. This product is to be used with UL and cUL listed PCs.
4. Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
5. Use caution when installing or modifying telephone lines.
6. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a
remote risk of electrical shock from lightning.
7. Do not use a telephone in the vicinity of a gas leak.
8. To reduce the risk of fire, use only 26 AWG or larger telecommunication line cord.
Caution
Danger of explosion if battery is incorrectly replaced.
A lithium battery on the voice/fax channel board provides backup power for the time keeping capability.
The battery has an estimated life expectancy of ten years.
When the battery starts to weaken, the date and time may be incorrect. If the battery fails, the board must
be sent back to Multi-Tech Sytems for battery replacement.
E&M, FXS, and Ethernet ports are not designed to be connected to a Public Telecommunication Network.