Miller Electric INTEGRA 201/241 - Manual (Page 11)

OM-188 414 Page 7
2-5. Installing Drive Roll and Wire Inlet Guide
ST-150 227-C
1 Securing Screw
2 Inlet Wire Guide
Loosen screw. Slide tip as close to
drive rolls as possible without touch-
ing. Tighten screw.
3 Wire Tension Wheel
4 Drive Roll
Install correct drive roll for wire size
and type.
5 Drive Roll Tension Assembly
Turn nut one click to secure drive
roll.
2
4
1
3
5
2-6. Installing Wire Spool and Adjusting Hub Tension
ST-072573-B
When a slight force is needed to turn spool, tension is set.
15/16 in
Tools Needed:
2-7. Electrical Service Guide
201 241
Input Voltage 230 230
Input Amperes at Rated Output 26 35
Max Recommended Standard Fuse or Circuit Breaker Rating in Amperes 26 35
** Input Conductor Size in mm 2 4 4
** Grounding Conductor Size in mm 2 4 4
** Power cord supplied with the unit is sized for 230V operation. Larger power cord may be required for cable lengths greater than 3 meters. C
onsult national and local regulations.