Muratec MFX-1430 - Manual (Page 83)

5-24 Using the Web Browser
Item Description
A Name This name will be displayed in the “From” field when you
send e-mail.
Up to 40 characters can be registered.
E-mail Address Enter the e-mail address that is assigned to your machine.
Up to 50 characters can be registered.
B Sending mail
(SMTP) Server
Enter the domain name or IP address of the SMTP server
used for sending e-mail.
When entering a domain name, it can be entered up to 50
characters.
Receiving mail
(POP3) Server
Enter the domain name or IP address of the POP3 server
used for receiving e-mail.
When entering a domain name, it can be entered up to 50
characters.
User ID for
POP3
Enter the user ID for the POP3 server.
Up to 50 characters can be registered.
Password for
POP3
Enter the password for the POP3 server.
Up to 50 characters can be registered.
Check for New
Mail
Set the interval at which the mail server is checked for
new mail. The minimum value is 5 seconds and the maxi-
mum is 99 hr 59 min 59 sec.
The default value is 10 min.
If you want to check for mail manually, set all of these
values to “0”. In this case, you can receive an arrived e-mail
by the following procedures.
<Receiving e-mail manually>
1. Press [FAX] on the control panel of your machine.
2. Press [Others] on the display.
3. Press [Next] to show the next screen.
4. Press [Check Mail].
Receive before
Send
For some providers, POP authentication is required before
sending (send request to SMTP server). In this case, check
this item.
SMTP Port No. Enter the SMTP port number. (0–65535)
Normally, set to “25”.
POP3 Port No. Enter the POP port number. (0–65535)
Normally, set to “110”.
Select POP3
Auth. Method
APOP (Authenticated POP) is a POP security protocol that
encrypts the POP password when connecting with the POP
server.
If APOP is available on the POP server you are using,
select “APOP”. Otherwise, select “Standard”.
Sender Information
Mail Server