Muratec MFX-1430 - Manual (Page 87)

5-28 Using the Web Browser
Item Description
D Show
recipients on
Tx e-mail
Select whether to list every recipients on the transmitted
e-mail (privacy issue).
E When mail
that cannot
be analyzed is
received
In some cases, received e-mail cannot be correctly printed
due to the format of a received file. This mode allows you
to either return an error message to the sender or have the
message forwarded to another inbox.
• Return.error.notice.to.author
Returns an error notice to the author
• Return.mail.to.author
Returns the original e-mail to the author.
• Forward.mail.to.others
Forwards the e-mail to another e-mail address without
returning it to the author. You can set just one e-mail
address in which to forward mail that can not be ana-
lyzed. The forwarding e-mail address can contain up to
50 characters
F Request receipt
verification
when sending
mail
This sets whether to request the receiver for delivery check
(DSN) or reading check (MDN) when sending e-mail.
• Delivery.Status.Notification.(DSN).from.receive.
server
Requests a delivery confirmation.
• Message.Disposition.Notification.(MDN).showing.
that.recipient.read.the.mail
Requests a read receipt.
• Request.both.reception.notifications
Requests both a delivery confirmation and a read receipt.
• Do.not.request.either.reception.notifications
The delivery notification and read receipt will not be
requested.
NOTE: Some mail servers and e-mail reception software
will not respond to these requests.
G When mail
requesting
MDN is
received
Select whether to return a MDN (Message Disposition
Notification) when e-mail is received for which the sending
side requests an MDN.
• Do.not.send.MDN
Not reply a MDN.
• .Send.MDN
Reply a MDN.
[Specify.MDN.Recipients].
This is set for replying to MDN only for e-mail received
from specific e-mail addresses or domain names.
Click the [Specify MDN Recipients], then register an
e-mail address or domain name. Up to five can be regis-
tered.
H Initialize Initialize the e-mail settings. The settings will return to
the factory default setting.