Metrologic Instruments IS4910 Series - Manual (Page 33)

27
IS4910 D
EVICE
D
RIVER
Value Type Description
GPIO_CIF_FV DWORD
Specifies the GPIO pin connected to the “VSYNC” signal.
If it’s not specified the driver fails to load.
GPIO_CIF_LV DWORD
Specifies the GPIO pin connected to the “HSYNC” signal.
If it’s not specified the driver fails to load.
GPIO_CIF_PCLK DWORD
Specifies the GPIO pin connected to the “PCLK” signal.
If it’s not specified the driver fails to load.
GPIO_CIF_DD0 DWORD
Specifies the GPIO pin connected to the “D0” signal.
If it’s not specified the driver fails to load.
GPIO_CIF_DD1 DWORD
Specifies the GPIO pin connected to the “D1” signal.
If it’s not specified the driver fails to load.
GPIO_CIF_DD2 DWORD
Specifies the GPIO pin connected to the “D2” signal.
If it’s not specified the driver fails to load.
GPIO_CIF_DD3 DWORD
Specifies the GPIO pin connected to the “D3” signal.
If it’s not specified the driver fails to load.
GPIO_CIF_DD4 DWORD
Specifies the GPIO pin connected to the “D4” signal.
If it’s not specified the driver fails to load.
GPIO_CIF_DD5 DWORD
Specifies the GPIO pin connected to the “D5” signal.
If it’s not specified the driver fails to load.
GPIO_CIF_DD6 DWORD
Specifies the GPIO pin connected to the “D6” signal.
If it’s not specified the driver fails to load.
GPIO_CIF_DD7 DWORD
Specifies the GPIO pin connected to the “D7” signal.
If it’s not specified the driver fails to load.
GPIO_TRIGGER DWORD
Specifies the GPIO pin connected to the “Trigger” signal.
If it’s not specified the driver fails to load.
GPIO_ILLUM DWORD
(Optional) Specifies the GPIO pin connected to the “Illum_ON”
signal. No default value.
GPIO_AIMER DWORD
(Optional) Specifies the GPIO pin connected to the “Aimer”
signal. No default value.