Marantz SR4300 - Manual (Page 17)

13
ENGLISH
DIGITAL DIGITAL
IN IN
OUT OUT
DIG-1 IN DIG-1 IN DIG-2 IN DIG-2 IN DIG.OUT DIG.OUT
OPT OPT DIG-4 IN DIG-4 IN DIG-3 IN DIG-3 IN DIG.OUT DIG.OUT
COAX COAX
SURROUND SURROUND
BACK BACK R R SURROUND SURROUND L L L L FRONT FRONT CENTER CENTER R R
VIDEO VIDEO S-VIDEO S-VIDEO
IN IN OUT OUT IN IN OUT OUT IN IN OUT OUT IN IN IN IN IN IN OUT OUT
DSS DSS // VCR2 VCR2 VCR1 VCR1 DVD DVD
AUDIO AUDIO
TV TV TAPE TAPE CD CD CDR CDR // MD MD SUB SUB WOOFER WOOFER CENTER CENTER CENTER CENTER
FRONT FRONT FRONT FRONT SURROUND SURROUND SURR. SURR.
BACK BACK SURROUND SURROUND SUB SUB
WOOFER WOOFER
SURR. SURR.
BACK BACK
6.1CH INPUT 6.1CH INPUT
L L
R R
IN IN
MONITOR MONITOR
OUT OUT VCR1 OUT VCR1 OUT VCR1 IN VCR1 IN DVD IN DVD IN
L L
R R
IN IN IN IN OUT OUT OUT OUT
PRE OUT PRE OUT
OUT OUT
MONITOR MONITOR
IN IN
TV TV DSS DSS // VCR2 VCR2 DVD DVD VCR1 VCR1
IN IN
GND GND
AM AM
FM FM
ANTENNA ANTENNA
((75 75 Ω Ω ))
REMOTE REMOTE
CONTROL CONTROL
MODEL NO. SR4300
SPEAKER SYSTEMS SPEAKER SYSTEMS
SWITCHED 100W 1A MAX SWITCHED 100W 1A MAX
UNSWITCHED 100W 1A MAX UNSWITCHED 100W 1A MAX
AC OUTLET (120V 60Hz) AC OUTLET (120V 60Hz)
SURROUND
BACK R R SURROUND L L L L FRONT CENTER R R
SPEAKER SYSTEMS
SUB SUB WOOFER WOOFER
INVERT
OUTPUT INPUT
LEVEL BTL REMOTE CONT. EXT. CONT. IN
VIDEO/ +5~13V DC SYSTEM OUT OUT
INPUT
MASTER SLAVE
MIN MAX IN
F U SE
SPEAKER SYSTEM
MINIMUM 4 OHMS
CONNECTING SPEAKERS
CONNECTING SPEAKER WIRE
1.
Strip away approx. 10 mm of wire insulation.
2.
Twist the bared wire ends tight to prevent short circuits.
3.
Loosen the knob by turning counterclockwise.
4.
Insert the bare part of the wire into the hole in the side of each
terminal.
5.
Tighten the knob by turning clockwise to secure the wire.
Cautions:
• Be sure to use speakers with the specified impedance shown on
the rear panel of this unit.
• To prevent damage to circuitry, do
not let the bare speaker wires touch
each other and do not let them touch
any metal part of this unit.
• Do not touch the speaker terminals
when the power is on. It may cause
electric shocks.
• Do not connect more than one
speaker cable to one speaker terminal. Doing so may damage
this unit.
Note:
• Be sure to connect the positive and negative cables for the
speaker properly. If they are miss-connected, the signal phase
will reversed and the signal quality will be corrupted.
CONNECTING A SUBWOOFER
Use the PRE OUT SUBWOOFER jack to connect a powered
subwoofer (power amplifier built in ).
If your subwoofer is passive type (power amplifier is not built in),
connect a monaural power amplifier to the PRE OUT SUBWOOFER
jack and connect the subwoofer to the amplifier.
1. 2.
3. 4. 5.
POWERED
SUBWOOFER
POWER
AMPLIFIER
PASSIVE
SUBWOOFER
FRONT
RIGHT LEFT
SURROUND
SURROUND
BACK
CENTER
or
RIGHT LEFT
CONNECTING BANANA PLUG
Banana plug connections are also possible.
Tighten the knob by turning clockwise and then insert the banana plug.
3/8 inch
(10 mm)