Miele KFN 9755 iDE EN - Manual (Page 34)

"
nA" appears in the temperature display for the freezer section.
The temperature in the freezer section
has risen too high at some point
during the last few days because of a
power failure.
^ Press the alarm off button while "nA" is
lit in the display.
The display will show the warmest
temperature reached in the freezer
during the power failure for about 1
minute. The display will then revert to the
current temperature in the freezer
section.
After the power failure the appliance will
continue running at the last temperature
set, there is no need to re-set.
The ice cube maker will not turn on.
Possible fault Solution
The appliance is not plugged in. Check that the appliance is connected
to the power supply.
The ice cube maker is not producing any ice cubes.
When the appliance is turned on for the very first time, it can take up to 24 hours
for the first ice cubes to drop out of the ice cube maker and collect in the
container.
The water supply line was not primed
(purged of air) before the appliance
was used for the first time. Contact Miele Technical Service.
The appliance is not turned on. Check that the appliance is switched on,
using the main switch on the right side.
The ice cube maker is not turned on. See "Ice cube maker - Turning on".
The water supply is not open. See "Plumbing".
The indicator light on the ice cube maker is flashing.
A fault has occurred. Contact Miele Technical Service.
Frequently asked questions
34