Miele KFN 9755 iDE EN - Manual (Page 43)

Ventilation grill
During construction the ventilation grill
can be built-in.
^ Cut an opening into the plinth b, as
shown in the illustration above.
^ Place the ventilation grill a into the
cut-out.
^ Slide the clips c, from the back, into
the ventilation grill until the hooks
connect with the plinth.
^ Install the plinth with the inserted
ventilation grill.
Before installation
^ Remove the cover strip, the sealing
strip and other accessories from the
inside and from the exterior rear wall
of the appliance.
^ Do not remove the spacers from the
rear wall of the appliance. They
ensure that there is enough space
between the rear wall of the
appliance and the wall.
^ Remove the cable clips from the rear
of the appliance.
^ Remove the red transport fixing a,
and use the supplied plug
b to close
the empty hole.
^ Check that all the parts on the rear
the appliance can move freely. Bend
any parts carefully if needed.
Installation
43