Moxa Technologies 2140 - Manual (Page 17)

Getting Started
Rear Panel
Before powering on the VPort 2140 Video Server:
1. Connect your camera’s video output with the BNC video input.
2. Connect I/O devices (such as sensors or alarms) with VPort’s GPIO Terminal Block.
3. Connect the hub or switch on the LAN to the VPort’s 10/100 Mbps Ethernet port.
4. Connect VPort’s COM port with your camera’s COM port if you are using a PTZ Camera.
Running the IP Installer Program
To run the IP installer program, double click on the “IPinstaller.exe” program located on the
software CD.
VPort 2140 User’s Manual 2-3