Moxa Technologies 2140 - Manual (Page 44)

settings. After the configuration is done, click on Close to close this window. If the
configurations are changed without saving, they will only be used until the next time the system
starts up.
Camera Setting
1. Camera type
The default camera type of VPort 2140 is Fixed camera, which means it is a general camera
without motorized function. If you wish to select a PTZ camera, you also need to select the
COM port that this PTZ camera is connected to, and the PTZ camera’s ID to activate it.
Click on Save to validate the camera type.
2. Preset position setting of Motorized PTZ camera
Below the camera type setting is the image of this camera, the control buttons of PAN/ TILT/
ZOOM/ FOCUS and the preset position setting. The administrator can use the control
buttons to operate the camera’s image to set the preset position of this motorized PTZ
camera.
Motion Detection
Each camera has its own separate motion detection settings. The settings, which include Object
size and Sensitivity, allow administrators to fine tune the VPort to fit the environment:
1. Object size sets the minimum size of objects whose motion will be detected. (E.g., if Object
VPort 2140 User’s Manual 4-10