Multi-Tech Systems MT5600BL - Manual (Page 37)

3 Using the Front Panel
29
DIALBACKUP/LL OPTIONS. The following screens are used to configure dial
backup for four-wire leased line operation. For more information, see Chapter 7,
“Leased Line Operation.”
DIAL BACKUP NUMBER. Use to enter a dial backup number.
To scroll through a list of digits and characters, press the áß
and
â buttons. To go to the next position, press the à button.
To back up or to exit without saving, press the à button several
times. To save the number, press the Enter button.
TIME TO RESTORE (S15). Use to set how frequently leased
line restoral attempts occur when the modems are in dial back-
up mode. The restore time interval can be set from 10 to 255
minutes in one minute increments. Same as the S15= command.
DIALBACKUP TIME (S17). Use to set how long the modem
waits after a leased line failure before it attempts a dial backup
connection. The timer can be set from 1 to 255 minutes in one
minute increments. Same as the S17= command.
CALLBACK SECURITY. Use the à and Enter buttons to turn callback security on
or off. Same as the #DB0 and #DB1 commands. For more information about callback
security, see Chapter 6, “Callback Security.”
PASSWORD SETUP. Use to enter callback security passwords
in memory locations 1–30. Each password must be six to ten
characters in length. To scroll through a list of digits and charac-
ters, press the
áß and â buttons. To go to the next position,
press the
à button. To back up or to exit without saving, press
the à button several times. To save the password, press the
Enter button. Same as the #CBP= command.
CALLBACK NUMBER. Use to enter callback security phone
numbers in memory locations 1–30. Each number can be up to
30 characters long. Same as the #CBN= command.
Remote Configuration Options
The following screens are used to configure remote configuration options. For more
information about remote configuration, see Chapter 5, “Remote Configuration.”
ENABLE/DISABLE R.C. Use the
à and Enter buttons to turn
remoteconfiguration on or off.
REMOTE CONFIG. PASSWORD. Use to enter the remote con-
figuration password. To scroll through a list of digits and char-
acters, press the
áß and â buttons. To go to the next position,
press the à button. To back up or to exit without saving, press
the
à button several times. To save the password, press the
Enter button.