Miller Electric D-74DX - Manual (Page 24)

OM-1500-7 Page 20
SECTION 6 − OPERATION
6-1. Operational Terms
The following is a list of terms and their definitions as they apply to this wire feeder:
General Terms:
Cold Wire Jog Feeding wire without contactor or gas valve being energized.
Sequence A portion of the weld program, such as preflow, run-in, start, weld, crater, burnback, and postflow.
Weld Program A group of sequences that make up a weld cycle.
6-2. Power Switch
1 Power Switch
1
Ref. 803 072
1 Left/Right Select Switch
Pressing the Left/Right Select
switch allows the operator to
choose which side of the units’ con-
trols will operate.
6-3. Left/Right Select Switch
1
Ref. 803 053
.
Depressing the Left or Right
Gun Trigger also allows the
operator to enable the con-
trols on that side of the unit.