Multi-Tech Systems MultiFRAD FR2201 - Manual (Page 10)

10
MultiFRAD II User Guide
Shunts
There are three shunts (Figure 1-3) on the printed circuit board for the trunk and the data channels.
Trunk RS232
Shunt Position
Trunk V.35
Shunt Position
Channel 1 V.35
Shunt Position
Channel 2 V.35
Shunt Position
Figure 1-3. Shunts
The MultiFRAD has separate shunts for the trunk and both data channels. Both the default RS232
Shunt Position and the V.35 position for the Trunk are identified. The V.35 positions for the Channel
shunts are also shown. To change the position of a shunt, refer to the V.35 Shunt procedure in
Chapter 2.