Muratec MFX-1350 - Manual (Page 152)

10-3 u
ser settInGs
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
u
ser
sett
In
G
s
05.Energy Save Mode Set the machine to conserve power when not in use.
On The machine saves power consumption after the specified
idle time elapses.
Off Cancel the energy save mode.
NOTE:
•The idle time can be changed in the “Initial setting” mode (see pages 1-14 to 1-16.)
•While the machine is in the energy save mode, the machine shows “Energy Save Mode”
on the LCD, but all the lights on the control panel and scanner lamp will not be off.
06.Fax & Copy Make a copy of your document each time it is transmitted. (See page 4-19.)
07.Primary Mode The machine returns to the primary mode when the standby status contin-
ues for longer than 3 minutes after finishing the sending or printing jobs.
With this setting, the machine always starts up in the primary mode.
In default settings, the copy mode is set for the primary mode. However,
you can change the primary mode to the fax mode or to the scan mode.
08.Service Mode For technical support. Do NOT turn this setting to “On” without an
authorized technician’s advice.
09.Date & Time Enter the current date and time using 24-hour format.
10.Paper Source Set the usage rules for the paper cassettes and bypass tray.
Cassette1
You can choose one of the following for cassette 1.
Fax/Copy It is used for fax printing, list printing and
copying.
Not Used Cassette 1 is not used for faxing and copying.
It can be used for the separator page function
(page 5-14) or PC printing.
Fax It is used only for fax printing and list printing.
Copy It is used only for copying.
Cassette2 You can choose one of the following for cassette 2.
Fax/Copy It is used for fax printing, list printing and
copying.
Not Used Cassette 2 is not used for faxing and copying.
It can be used for the separator page function
(page 5-14) or PC printing.
Fax It is used only for fax printing and list printing.
Copy It is used only for copying.
Bypass tray You can choose one of the following for Bypass tray.
Fax/Copy It is used for fax printing, list printing and
copying.
Not Used Bypass tray is not used for faxing and copying.
It can be used for the separator page function
(page 5-14) or PC printing.
Fax It is used only for fax printing and list printing.
Copy It is used only for copying.
NOTE:
•The “Cassette2” appears only when the optional second cassette has been installed.
•For details of PC printing, refer to the PDF manual on the GDI Pritner/Scanner Driver
CD supplied with the machine.
11.Page Counter You can confirm the total number of printed and scanned page.
(See page 8-8.)